Home -------- Contact/Email

SDS of Zinc Chloride Solution Anhydrous & IP BP Ph Eur USP AR ACS Analytical Reagent Grade Manufacturers

CAS Number 7646-85-7

Zinc Chloride Anhydrous Solution Powder BP Ph Eur USP Grade Manufacturers.

Zinc Chloride Anhydrous SDS, Safety Data Sheet
MSDS, Material Safety Data Sheet
12-Sept-22

1. Product Identification

Product Name & Other Names: Zinc Chloride Anhydrous or Zinc Dichloride or Zinc Butter.
CAS No.: 7646-85-7
EINECS EC Number: 231-592-0
Molecular Weight: 136.30
Chemical Formula: ZnCl2
Relevant uses and uses advised against (if any): Industrial Manufacturing.

2. Hazards Identification

GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008

Acute Toxicity Oral Category 4, H302
Skin corrosion/irritation Category 1A, B, C, H314
Hazardous to the aquatic environment, long-term hazard Category 2, H411

Labeling according to GHS & Regulation (EC) No 1272/2008

GHS Label Elements
Aquatic Toxicity
Aquatic Toxicity

GHS Label Elements
Corrosive
Corrosive

Signal Words: Danger

Hazard statements:
H302 Harmful if swallowed.
H314 Causes severe skin burns and eye damage.
H411 Toxic to aquatic life with long lasting effects.

Precautionary statements:
P262: Do not get in eyes, on skin, or on clothing.
P264 Wash skin thoroughly after handling.
P270: Do not eat, drink or smoke when using this product.
P273 Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P310: Immediately call a POISON CENTER or doctor/ physician.
P314: Get Medical advice/attention if you feel unwell.
P330: Rinse mouth.
P301+P312: IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell.
P302+P352: IF ON SKIN: Wash with soap and water.
P305+ P351 + P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
P332+P313: If skin irritation occurs: Get medical advice/attention.
P337+P313 If eye irritation persists: Get medical advice/ attention.
P360: Rinse immediately contaminated clothing and skin with plenty of water before removing clothes.
P362: Take off contaminated clothing and wash before reuse.
P391: Collect spillage.
P404: Store in a closed container.
P501 Dispose of contents/ container to an approved waste disposal plant.

3. Composition/Information on Ingredients

Product Name & Other Names: Zinc Chloride Anhydrous or Zinc Dichloride or Zinc Butter.
CAS No.: 7646-85-7
EC Number: 231-592-0
Percent: 97 - 100%

4. First Aid Measures

Always seek medical attention after first aid measures are provided.

Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical attention immediately.
Ingestion: If swallowed, DO NOT INDUCE VOMITING. Give large quantities of water. Never give anything by mouth to an unconscious person. Get medical attention immediately.
Skin Contact: Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Get medical attention immediately. Wash clothing before reuse. Thoroughly clean shoes before reuse.
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes, lifting lower and upper eyelids occasionally. Get medical attention immediately.

5. Fire Fighting Measures

Fire: Not considered to be a fire hazard.
Fire Extinguishing Media: Use water spray, alcohol-resistant foam, dry chemical, or carbon dioxide. Use means suitable for extinguishing surrounding fire.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes. Fire-extinguishing work is done from the windward and the suitable fire-extinguishing method according to the surrounding situation is used.

6. Accidental Release Measures

Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach face the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Do not inhale dust, vapors, mist, or gas. Avoid dust formation. Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite). Use a shovel to put the material into a convenient waste disposal container.

7. Handling and Storage

Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents, cyanides, and sulfides.

8. Exposure Controls/Personal Protection

Airborne Exposure Limits:
OSHA Permissible Exposure Limit (PEL): 1 mg/m3 (TWA) 8H, as fume.
ACGIH Threshold Limit Value (TLV): 1 mg/m3 (TWA); 2 mg/m3 (STEL) for fume
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures below the Airborne Exposure Limits.
Personal Respirators (NIOSH Approved): If the exposure limit is exceeded, a full face piece respirator with dust/mist filter may be worn up to 50 times the exposure limit or the maximum use concentration specified by the appropriate regulatory agency or respirator supplier, whichever is lowest.
Skin Protection: Wear impervious protective clothing, including boots, gloves, lab coat, apron or coveralls, as appropriate, to prevent skin contact.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice.

9. Physical and Chemical Properties

Appearance: Fine white crystalline powder or granules.
Odor: It is odorless.
Odor threshold: Not available.
pH: around 4 Aqueous solution
Relative density: around 2.9
Boiling Point: 732C (1350F).
Melting Point: 290C (554F).
Flash point: Not available.
Auto-ignition temperature: Not available.
Decomposition temperature: Not available.
Upper/lower flammability or explosive limits: Not available.
Vapor pressure: Not available.
Vapor density: Not available.
Evaporation rate: Not available.
Flammability (solid, gas): Not available.
Partition coefficient: n-octanol/water: Not available.
Solubility: Soluble 423 g/l00 g water @ 25C (77F)
Viscosity: Not available.

10. Stability and Reactivity

Stability: Stable under ordinary conditions of use and storage.
Hazardous Decomposition Products: When heated to decomposition it emits toxic fumes of chlorine and zinc oxide.
Hazardous Polymerization: Will not occur.
Incompatibilities: Cyanides and sulfides, powdered zinc. When mixed with potassium, a weak explosion will occur on impact.
Conditions to Avoid: Incompatibles.

11. Toxicological Information

Oral rat LD50: 350 mg/kg.
Carcinogenicity: No component of this product present at levels greater than or equal to 0.1% is identified as possible or confirmed human carcinogen by IARC, ACGIH, OSHA and NTP.
Teratogenic Effects: Not available.
Mutagenic Effects: Not available.
Developmental Toxicity: Not available.
Reproductive Effects: No information available.

12. Ecological Information

Toxicity to fish: LC50 - Cyprinus carpio (Carp) - 0,4 - 2,2 mg/l - 96,0 h
Toxicity to daphnia and other aquatic invertebrates: EC50 - Daphnia magna (Water flea) - 0,2 mg/l - 48 h
Environmental Toxicity: Very toxic to aquatic organisms; may cause long term adverse effects in the aquatic environment.
Results of PBT and vPvB assessment: This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.

13. Disposal Considerations

Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste disposal facility. Processing use or contamination of this product may change the waste management options.

14. Transport Information

DOT USA, TDG Canada & ADR/RID Europe:
Proper Shipping Name: ZINC CHLORIDE, ANHYDROUS
Hazard Class: 8; Packing Group: III
UN/NA: UN2331
IMDG/IMO & IATA/ICAO:
Proper Shipping Name: ZINC CHLORIDE, ANHYDROUS
Hazard Class: 8; Packing Group: III
UN/NA: UN2331

15. Regulatory Information

USA:
SARA 311/312: Acute: Yes; Chronic: Yes.

Section 16 - Additional Information

DISCLAIMER: The information and recommendations set forth herein (hereinafter "Information") are presented in good faith and believed correct as of the date hereof. It is compiled from various sources and it is not necessarily all inclusive nor fully adequate in every circumstance. In addition, these suggestions should not be confused with nor followed in violation of applicable laws, regulations, rules or insurance requirements applicable. This MSDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Individuals receiving the information must exercise their independent judgment in determining its appropriateness for a particular purpose.

Zinc Chloride Anhydrous Manufacturers Zinc Chloride Solution Suppliers

Zinc Chloride Solution Anhydrous IP BP Ph Eur USP ACS AR Analytical Reagent manufacturers:

Muby Chemicals & Associated Cos
BANDEALI BUILDING, CHINCHBUNDER, MUMBAI 400009, INDIA.
TEL: 91-22-23728264. Gujarat & Mumbai India.

info(At the Rate i.e. @)mubychem(dot)com

India Manufacturers Logo
Copyright and Usual Disclaimer is Applicable
Last updated 12-sep-22

Exports to USA UAE Europe South Africa Tanzania Kenya Uganda Egypt Nigeria Turkey Brazil Chile Argentina Dubai Cameroon Guatemala Mexico

Exports to USA UAE Europe South Africa Tanzania Kenya Uganda Egypt Nigeria Turkey Brazil Chile Argentina Dubai Cameroon Guatemala Mexico etc.

Barter

They who love thee on this earth, keep calling on thee and chanting thy beads
Lest thou forgetest.

They assign the credit of their hard work to your blessings
They keep you amused.

They come to thy temple with baskets of fruits, as if you were a glutton
They deny the same to their children.

They offer you milk for a bath and burn the ghee
They hardly understand the meaning of it.

They bring gold and diamonds. They come with beating of drums
They love to advertise their offerings.

They offer you a small bribe as advance for booty, called lottery
They love to dream.

I do not bow down at your door
I do not bargain for booty
Your promise of the heaven does not lure me
Your hell-fire does not scare me
I do not even know the proper method of prayer
I do not offer any thing to you
Ages have gone by and I have not seen you my lord
Yet my love for you keeps waiting for you.