SDS of Sodium Selenite Pure & BP Ph Eur Grade Manufacturers
CAS Number 26970-82-1 & 10102-18-8
Please visit SDS, Safety Data Sheet of Sodium Selenite Pure & BP Ph Eur Grade Manufacturers.
Sodium Selenite SDS, Safety Data Sheet
MSDS, Material Safety Data Sheet 09-Sept-22Section 1. Product Information
Product Name & Other Names: Sodium Selenite pentahydrate.
Synonym: Selenious acid disodium pentahydrate salt, Disodium selenite pentahydrate
Chemical Formula: Na2SeO3-5H2O (Na2SeO3 for anhydrous)
Molecular Weight: 263.01 g/mol (172.95 for anhydrous)
CAS No.: 26970-82-1
EINECS EC Number: 233-267-9
Relevant uses and uses advised against (if any): Industrial Manufacturing.Section 2: Hazards Identification
GHS, Globally Harmonized System Classification in accordance with 29 CFR 1910
Classification according to Regulation (EC) No 1272/2008Acute toxicity, Oral (Category 1, 2), H300
Sensitization, Skin (Category 1) H317
Acute toxicity, Inhalation (Category 3), H331
Chronic aquatic toxicity (Category 2), H411Labeling according to GHS & Regulation (EC) No 1272/2008
GHS Label Elements
Aquatic ToxicityGHS Label Elements
ToxicSignal Words: Danger
Hazard statements:
H300 Fatal if swallowed.
H317 May cause an allergic skin reaction.
H331 Toxic if inhaled.
H411 Toxic to aquatic life with long lasting effects.
Precautionary statements:
P260: Do not breathe dust/fume/gas/mist/vapors/spray.
P264: Wash --- thoroughly after handling.
P270: Do not eat, drink or smoke when using this product.
P271: Use only outdoors or in a well-ventilated area.
P272: Contaminated work clothing should not be allowed out of the workplace.
P273: Avoid release to the environment.
P280: Wear protective gloves/protective clothing/eye protection/face protection.
P314: Get medical advice/attention if you feel unwell.
P330: Rinse mouth.
P301+310: IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician.
P302+352: IF ON SKIN: Wash with soap and water.
P333+313: If skin irritation or a rash occurs: Get medical advice/attention.
P304+340: IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for breathing.
P363: Wash contaminated clothing before reuse.
P391: Collect spillage.
P405: Store locked up.
P403+233: Store in a well-ventilated place. Keep container tightly closed.
P501: Dispose of contents/container in accordance with local/regional/national/international regulation.Section 3: Composition and Information on Ingredients
Product Name & Other Names: Sodium Selenite pentahydrate.
CAS No.: 26970-82-1
EINECS EC Number: 233-267-9Section 4. First Aid & Procedure
Always get medical attention after the first aid is over.
Ingestion: Induce vomiting immediately as directed by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention.
Skin: Immediately flush skin with plenty of water for at least 15 minutes. Remove and wash contaminated clothing and shoes before reuse. Get medical attention if irritation develops.
Eyes: Immediately flush eyes with plenty of water for 15 minutes, occasionally lifting upper and lower eyelids. Hold eyelids apart during irrigation. Get medical attention.
Inhalation: Remove person to fresh air. If breathing is difficult, give oxygen. If not breathing administer artificial respiration. Get medical attention.Section 5. Fire Fighting Measures
Flash Point: N/A
Extinguishing Medium: Water spray, alcohol-resistant foam, dry chemical or carbon dioxide.
Special hazards arising from the substance/ mixture: Sodium oxides, Selenium/selenium oxides.
Special Information: In the event of a fire, wear full protective clothing and NIOSH-approved self-contained breathing apparatus with full face piece operated in the pressure demand or other positive pressure mode. At high temperatures under fire conditions, it may produce toxic or irritating fumes. Fire-extinguishing work is done from the windward and the suitable fire-extinguishing method according to the surrounding situation is used. Uninvolved persons should evacuate to a safe place.Section 6. Spills and Disposals
Personal precautions, protective equipment, and emergency procedures: Avoid breathing dust/fumes/gas/mist/vapors/spray. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.). Restrict unprotected personnel from the area. Prevent any contact with hot surfaces. Do not approach facing the wind.
Environmental precautions: Do not let the product enter drains, soil, or water sources.
Methods and materials used for containment Cleanup procedures and Storage: Do not inhale dust, vapors, mist, or gas. Avoid dust formation. Contain spilled material. Cover with an inert, non-combustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite). Use a shovel to put the material into a convenient waste disposal container.Section 7. Handling and Storage
Precautions for safe handling: Apply according to good manufacturing and industrial hygiene practices. Ensure proper ventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Wash thoroughly after handling. Do not drink, eat, or smoke while handling. Avoid contact with skin, eyes, and clothing. Minimize dust generation. Avoid breathing dust/fumes/gas/mist/vapors/spray. Keep container tightly closed. Avoid ingestion and inhalation. Use individual protective equipment (waterproof boots, suitable protective clothing, safety glasses, etc.).
Conditions for safe storage, including any incompatibilities: Store in cool, dry, and ventilated area away from heat sources and protected from sunlight in tightly closed original container. Keep air contact to a minimum. Store protected from heat, sparks and ignition sources and incompatible materials. Avoid contact with skin and eyes. Avoid inhalation of dust/mist/vapor. Do not store with incompatible materials like strong oxidizing agents and strong acids.Section 8. Exposure Controls & Personal Protection
Exposure Limits for Sodium Selenite:
OSHA PEL: 0.2 mg/COM Ceiling for Selenium compounds (as Se).
ACGIH TLV: 0.2 mg/CBM (TWA) Selenium compounds (as Se).
Engineering Controls: Use adequate exhaust ventilation to keep airborne concentrations below the allowable exposure limit.
Ventilation System: A system of local and/or general exhaust is recommended to keep employee exposures as low as possible.
Personal Respirators (NIOSH Approved): For conditions of use where exposure to dust or mist is apparent and engineering controls are not feasible, a particulate respirator may be worn.
Skin Protection: Wear protective gloves and clean body-covering clothing.
Eye Protection: Use chemical safety goggles and/or full face shield where dusting or splashing of solutions is possible. Maintain eye wash fountain and quick-drench facilities in work area.
Other Control Measures: Maintain good housekeeping in work area. Handle in accordance with good industrial hygiene and safety practice. Wash hands after handling.Section 9. Physical & Chemical Data
Appearance and Physical State: White solid
Odor: Not available.
Odor threshold: Not available.
pH Value: 7-9 at 50 g/l at 20C
Relative density: around 3.1
Melting point/freezing point: Not available.
Initial boiling point and boiling range: Not available.
Flash point: Not available.
Auto-ignition temperature: Not available.
Decomposition temperature: > 300C
Upper/lower flammability or explosive limits: Not available.
Vapor pressure: Not available.
Vapor density: Not available.
Evaporation rate: Not available.
Flammability (solid, gas): Not available.
Partition coefficient: n-octanol/water: Not available.
Solubility(ies): Easily soluble in hot water. Soluble in cold water. Insoluble in methanol, n-octanol.
Viscosity: Not available.Section 10. Stability and Reactivity
Chemical Stability: Stable under normal temperatures and pressures.
Incompatibility (Materials to Avoid): Strong oxidizing agents, Strong acids.
Conditions to Avoid: Incompatible materials, exposure to moist air or water, excessive heat.
Hazardous Decomposition Products: Sulfur oxides, oxides of Selenium.
Hazardous Polymerization: Will not occur.Section 11. Toxicological Information
Toxicity to Animals: LD50 Oral - Rat - 7 mg/kg.
Carcinogenicity: No component of this product present at levels greater than or equal to 0.1% is identified as possible or confirmed human carcinogen by IARC, ACGIH, OSHA and NTP.
Teratogenic Effects: Not available.
Mutagenic Effects: Not available.
Developmental Toxicity: Not available.
Reproductive Effects: No information available.Section 12. Ecological Information
Toxicity to fish: LC50 - Cyprinodon variegatus (sheep head minnow) - 4,5 - 12,0 mg/l - 96,0 h
Toxicity to daphnia and other aquatic invertebrates: EC50 - Daphnia magna (Water flea) - 7,9 mg/l - 48 h
Toxicity to algae: EC50 - Pseudokirchneriella subcapitata (green algae) - 3,2 - 10,0 mg/l - 72 h
Ecotoxicity: Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Results of PBT and vPvB Assessment: This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.Section 13. Disposal Suggestions
Dispose of in accordance with all applicable local, state, and federal regulations at an approved waste disposal facility.
Section 14. Transport and Label Information
DOT USA, TDG Canada & ADR/RID Europe:
UN-No UN 2630
Proper Shipping Name SELENITES (Sodium selenite pentahydrate)
Hazard Class 6.1; Packing Group I
IMDG/IMO
UN-No UN 2630
Proper Shipping Name SELENITES (Sodium selenite pentahydrate)
Hazard Class 6.1; Packing Group I
IATA:
UN-No UN 2630
Proper Shipping Name SELENITES (Sodium selenite pentahydrate)
Hazard Class 6.1; Packing Group ISection 15. Regulatory Information
USA:
SARA 311/312: Acute and Chronic Health Hazard.Section 16. Other Information
Disclaimer:
*****************************
Our company provides this MSDS sheet in good faith but makes no representation as to its comprehensiveness or accuracy. This SDS sheet is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. The above information has been compiled from various sources and has the possibility of discrepancy and being out-dated information. Individuals receiving the information must exercise their independent judgment and do further search in determining its appropriateness for a particular purpose. In no case shall our company be liable to loss or damages by the product user.
*****************************
Sodium Selenite Anhydrous and PentahydrateSodium Selenite Pure & BP Ph Eur Grade Manufacturers:
Muby Chemicals & Associated Cos
BANDEALI BUILDING, CHINCHBUNDER, MUMBAI 400009, INDIA.
TEL: 91-22-23728264. Gujarat & Mumbai India.info(At the Rate i.e. @)mubychem(dot)com
Copyright and Usual Disclaimer is Applicable
Last updated 9-sep-22
Exports to USA UAE Europe South Africa Tanzania Kenya Uganda Egypt Nigeria Turkey Brazil Chile Argentina Dubai Cameroon Guatemala Mexico etc.
Barter
They who love thee on this earth, keep calling on thee and chanting thy beads
Lest thou forgetest.They assign the credit of their hard work to your blessings
They keep you amused.They come to thy temple with baskets of fruits, as if you were a glutton
They deny the same to their children.They offer you milk for a bath and burn the ghee
They hardly understand the meaning of it.They bring gold and diamonds. They come with beating of drums
They love to advertise their offerings.They offer you a small bribe as advance for booty, called lottery
They love to dream.I do not bow down at your door
I do not bargain for booty
Your promise of the heaven does not lure me
Your hell-fire does not scare me
I do not even know the proper method of prayer
I do not offer any thing to you
Ages have gone by and I have not seen you my lord
Yet my love for you keeps waiting for you.